F27E, F295 and F298 - all from our CE - you need at least F27E for 3590H's
to work at all.

-----Original Message-----
From: Bob Booth - UIUC [mailto:booth AT UIUC DOT EDU]
Sent: 07 March 2003 15:00
To: ADSM-L AT VM.MARIST DOT EDU
Subject: Re: 3590 microcode


You were in the right place.

D01F.26E is the latest on the site.  Unfortunately, the documentation is
not up to date.  I have also heard of newer code for the 3590, but it is
not on any ftp site.  You may have to ask your CE to get an FMR tape for
you.

bob

On Fri, Mar 07, 2003 at 08:52:41AM -0500, Steve Roder wrote:
> Hi All,
>
>      With all the recent discussion here about I/O errors on tapes being
> the result of downleveled microcode, I went looking for the latest 3590E
> code, and all I could find was level 350, which we installed 15 months
> ago.  Can anyone point me at a download site for the newest code?  I tried
> ftp.software.ibm.com, but 350 was the latest, and service2.boulder.ibm.com
> has none at all, even though I got redirected there.
>
> Thanks,
>
>
> Steve Roder, University at Buffalo
> HOD Service Coordinator
> VM Systems Programmer
> UNIX Systems Administrator (Solaris and AIX)
> TSM/ADSM Administrator
> (spr AT buffalo DOT edu | (716)645-3564)

Any e-mail message from the European Central Bank (ECB) is sent in good faith 
but shall neither be binding nor construed as constituting a commitment by the 
ECB except where provided for in a written agreement.
This e-mail is intended only for the use of the recipient(s) named above. Any 
unauthorised disclosure, use or dissemination, either in whole or in part, is 
prohibited.
If you have received this e-mail in error, please notify the sender immediately 
via e-mail and delete this e-mail from your system.