9710 stuck tapes
1998-06-03 09:24:57
Hello Sam,
After removing the tape and placing it in one of the empty slots, run
the audit with the option checklabel=barcode. On ADSM version 2 for AIX
the command will be,
audit library libraryname checklabel=barcode
The first time you run the audit you might get a message saying that unable
to read the barcode in one of the slots, if that happens- run the
audit again and your audit should be clean.
Note: the robot does not move for the STK 9710 library when an audit is
done with the barcode option.
Hope this helps.
Mansoor Bajwa AT cpr DOT ca
Canadian Pacific Railway
ORIGNAL MESSAGE
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- 9710 stuck tapes, Sam Mauro
- 9710 stuck tapes, Sam Mauro
- Re: 9710 stuck tapes, Gamble, Susan M (Sue)
- Re: 9710 stuck tapes, Weeks, Debbie
- Re: 9710 stuck tapes, Paul Zarnowski
- Re: 9710 stuck tapes, Louie, James
- Re: 9710 stuck tapes, Bob Miller
- 9710 stuck tapes,
Mansoor Bajwa <=
- Re: 9710 stuck tapes, Shira Hayun
- Re: 9710 stuck tapes, Dan Giles
- Re: 9710 stuck tapes, Sam Mauro
- Re: 9710 stuck tapes, ADSM : Dist Stor Manager [mailto:ADSM-L
|
|
|