OK, this is really strange. It only works from within dsmc after the
second try!!!
I.e. if I start up dsmc and type the command it fails, just like from the
commandline. However, if I type it again, it works just fine! I didn't
notice this before because I had a 2nd window open where I never got out
of dsmc, so never noticed this.
Sure looks like a bug to me! Why would typing the same command a second
time allow it to work???
Thanks,
-Scott
________________________________________________________________________
________________________________________________________________________
L. Scott Emmons | CableData R&D Center - El Dorado Hills, CA, USA
Staff Software Engineer| Special Projects, Systems Development Dept
(916) 939-6088 | Views and content are my own, not CableData's
|