RE: [NV-L] Trapd Events 184.108.40.206.220.127.116.11.5
No need to applogize for asking questions. We've all have been there before.
One of the things you can try is to determine what device this is coming from.
There should be an IP address from where the SNMP trap is coming from in the
log files. After you have determined which device is sending the trap, see if
you can find a MIB file for that device. Sometimes you have to get them from
the company directly or you can find them at third party sites (i.e.,
Once you have find the correct MIB, you can then use a utility called mib2trap
that will take that MIB file and create an script for you with the correct
addtrap commands so you can add the trap definitions to the trapd.conf file.
Once this is done, you can reload the trapd.conf or you may want to restart the
NetView processes if the reload command doesn't appear to be working.
I hope this helps.
From: nv-l-bounces AT lists.ca.ibm DOT com on behalf of Amir, Mohammed -
Corporate Core - ICT Services
Sent: Thu 7/12/2007 04:26
To: nv-l AT lists.ca.ibm DOT com
Subject: [NV-L] Trapd Events 18.104.22.168.22.214.171.124.5
First question about netivew....I am new to Netview so people I apologise in
advance for any stupid questions.
I have a situation where I'm receiving loads of traps in trapd.log and most of
them are similar to the following:
? NO FMT IN TRAPD.CONF: Enterprise (126.96.36.199.188.8.131.52.5) generic:4 specific:0
Now this is what I have done to try and get rid of this problem
I have started xnmtrap and added a new Enterprise Name called Enterprise and an
Enterprise ID as 184.108.40.206.220.127.116.11.5 and then added an Event Name as
Authentication_Error and under generic trap I left that as Enterprise Specific
with the specific trap as 0. I reloaded the trapd.conf file with event -e
FMTCHG command and was hoping that this will get rid of the NO FMT bit but I'm
still getting then and this whole saga has left in confusion hence my plea for
help to you guys who have worked with this product for a while now.
Also is there a way to acknowledge these trap events so that they stop coming
into the trapd.log file once you start to action on it or you are aware of the
issue ....this is to stop the log file going into some kind of trap storm which
inadvertently affects demand poll and quicktest.
All help appreciated.
Senior Systems Engineer
Oxford County Council
Oxfordshire County Council - rated a four-star 'Excellent' council by the Audit
The information in this e-mail, together with any attachments, is confidential.
If you have received this message in error you must not print off, copy, use or
disclose the contents. The information may be covered by legal and/or
professional privilege. Please delete from your system and inform the sender of
the error. As an e-mail can be an informal method of communication, the views
expressed may be personal to the sender and should not be taken as necessarily
representing the views of the Oxfordshire County Council. As e-mails are
transmitted over a public network the Oxfordshire County Council cannot accept
any responsibility for the accuracy or completeness of this message. It is your
responsibility to carry out all necessary virus checks. You should be aware
that all emails received and sent by this Council are subject to the Freedom of
Information Act 2000 and therefore may be disclosed to other parties under that
NV-L mailing list
NV-L AT lists.ca.ibm DOT com
Unsubscribe:NV-L-leave AT lists.ca.ibm DOT com
http://lists.ca.ibm.com/mailman/listinfo/nv-l (Browser access limited to
internal IBM'ers only)