Fw: [NV-L] Predefined configurations from SNMP Collector NOT showing

Did you install NetView on a disk drive other than C:\? If so, your nvcollector configuration may not be correct. The solution is to open a command prompt, make your NetView disk the current disk, and then run the nvCollConfig.bat utility again. It is probably a good idea to switch to snmpCollect first and then back to nvcollectord.

John Thomas
SWG Client Support - Software
NetView Distributed Level 2 Customer Support
johnt AT us.ibm DOT com

http://www-306.ibm.com/software/support/

----- Forwarded by John Thomas/Raleigh/IBM on 05/14/2007 02:26 PM -----

Mario Behring <mariobehring AT yahoo DOT com>
Sent by: nv-l-bounces AT lists.ca.ibm DOT com

05/12/2007 04:25 PM

Please respond to
Tivoli NetView Discussions <nv-l AT lists.ca.ibm DOT com>

To	NetView List <nv-l AT lists.ca.ibm DOT com>
cc
Subject	[NV-L] Predefined configurations from SNMP Collector NOT showing

Hi list,

I've installed NV 7.1.5 on a Windows 2003 Server SE box and selected the nvcollectord option from the installation wizard. The installation was ok and the product is working fine.

However, the predefined Expressions that are supposed to appear when you are configuring a SNMP collection are not showing.......the _expression_ window remains empty no matter which Smartset you select.

Any help is appreciated.

Thank you.

Mario

It's here! Your new message!
Get new email alerts with the free Yahoo! Toolbar._______________________________________________ NV-L mailing list NV-L AT lists.ca.ibm DOT com Unsubscribe:NV-L-leave AT lists.ca.ibm DOT com http://lists.ca.ibm.com/mailman/listinfo/nv-l (Browser access limited to internal IBM'ers only)

_______________________________________________
NV-L mailing list
NV-L AT lists.ca.ibm DOT com
Unsubscribe:NV-L-leave AT lists.ca.ibm DOT com
http://lists.ca.ibm.com/mailman/listinfo/nv-l (Browser access limited to 
internal IBM'ers only)