Re: [NV-L] Finished scan?
2007-04-25 22:25:08
Those are 'hints'. First it goes through
that whole list and makes hints with just those two fields. Eventually
(probably before it makes 84K hints) it will start making networks and
segments to support the addresses and masks, if it knows them, then it
will make interfaces to put on the networks, and then it will make the
nodes. So doing it that way, with a very long explicit list, can look like
it takes a very long time. You might just give it overnight and
check again. It sounds pretty normal.
Probably in the long run it will take
the same amount of time, but there are other ways to approach it. One would
be to make the range rules, as I am sure you have tried, and then run a
ping script that pings all of those addresses from the outside. That would
be a 'one at a time' (one interface, network, and node) approach
that might give you more immediate feedback than the method you are using
now, which is more batch-oriented (make all the hints, then make all the
networks....etc).
One down side of doing it with a long
explicit list is that Netview kind of hopes that all those entries are
SNMP. You can end up with a lot of bad subnet assignments if you don't
have some routers in there first, so real subnets are created. Then the
things that are non-snmp are likely to be assigned to good subnets.
Cordially,
Leslie A. Clark
IT Services Specialist, Network Mgmt
Information Technology Services Americas
IBM Global Services
(248) 552-4968 Voicemail, Fax, Pager
"Kain, Becki \(B.\)"
<bkain1 AT ford DOT com>
Sent by: nv-l-bounces AT lists.ca.ibm DOT com
04/25/2007 02:36 PM
Please respond to
Tivoli NetView Discussions <nv-l AT lists.ca.ibm DOT com> |
|
To
| "Tivoli NetView Discussions"
<nv-l AT lists.ca.ibm DOT com>
|
cc
|
|
Subject
| [NV-L] Finished scan? |
|
Dear learned folks:
I have a seedfile that is 84444 entries long.
I don't see any other "A node added" records in my trapd.log
from restarting netmon. It looks like the discovery only took about
an hour. I tried to tease about the data with:
nvUtil e isNode=TRUE
But I have a lot of entries in the database
that look like this:
bkain1@fcis249:~ $ ovobjprint -s fcas534.dearborn.ford.com
OBJECTID
SELECTION NAME
OBJECT: 5480
FIELD ID
FIELD NAME
FIELD VALUE
10
Selection Name
"fcas534.dearborn.ford.com"
11
IP Hostname
"fcas534.dearborn.ford.com"
So isNode didn't pick it up.
Is discovery finished? Why aren't the
entries for most nodes being filled in?
Thanks _______________________________________________
NV-L mailing list
NV-L AT lists.ca.ibm DOT com
Unsubscribe:NV-L-leave AT lists.ca.ibm DOT com
http://lists.ca.ibm.com/mailman/listinfo/nv-l (Browser access limited to
internal IBM'ers only)
_______________________________________________
NV-L mailing list
NV-L AT lists.ca.ibm DOT com
Unsubscribe:NV-L-leave AT lists.ca.ibm DOT com
http://lists.ca.ibm.com/mailman/listinfo/nv-l (Browser access limited to
internal IBM'ers only)
|
|
|