Any advises on the above subject? I have several devices behind VPN tunnels that I have to monitor for availability as well as configuring events based on MIB variables thresholds......
I am having some difficulties like:
- some devices (routers mostly) are not being discovered by NV, but they answer ping and snmpwalk commands issued at the command line at the NV server.
- different clients connected through VPN tunnels have similar IP ranges, so the addresses the NV server actually
see are NAT addresses.
How can I work around these isues? Do I have to use CNAT? Is there any special configuration for NV to deal correctly with devices behind VPN tunnels?
Most tunnels are configured through PIX/ASA Cisco devices, and some through routers.
I am running NV 7.1.5 on a
Red Hat 4 server.
Thanks in advance.
Best regards,
Mario Behring