Thank you.. what is the trap that is sent?..
the doc states "send the event "PIX Firewall failover state
change".. I looked under the event configuration and can not find it in
nv6000 events. I can use this event to generate an email or popup
nv-l-bounces AT lists.ca.ibm DOT com [mailto:nv-l-bounces AT lists.ca.ibm DOT com] On Behalf Of Leslie Clark
Sent: Friday, December 08, 2006
To: Tivoli NetView Discussions
Subject: Re: [NV-L] cisco pix
Actually. netmon will monitor that failover for you and
generate a special event when it occurs. See the Fixpack 4 release notes:
Tivoli NetView provides support for monitoring the Cisco PIX Firewall Failover
conditions. NetView can monitor the failover state of the PIX devices during
normal status polling. When a failover occurs, a new event is generated
announcing whether the active addresses are on the primary or secondary device.
In addition, the operator can see on the map when the active addresses are on
the secondary device, which indicates that a failover has occurred and action
should be taken to prevent a further failure that disables the firewalls. The
management interface shows USER2 status, which is usually purple (by default).
This propagates to change the PIX device symbol to marginal. When the active
addresses are returned to the primary device, an event announces this fact and
the status on the map returns to Normal.
netmon.seed file to configure both the PIX Firewall Failover machines and to
set and lock the SNMP address.
For more information on the PIX Firewall Failover
support see the /usr/OV/doc/PixFailoverReadme.pdf file.
Leslie A. Clark
IT Services Specialist, Network Mgmt
Information Technology Services Americas
IBM Global Services
(248) 552-4968 Voicemail, Fax, Pager
<Catalina.Martinez AT tlc.state.tx DOT us>
by: nv-l-bounces AT lists.ca.ibm DOT com
12/08/2006 10:23 AM
Tivoli NetView Discussions <nv-l AT lists.ca.ibm DOT com>
"Tivoli NetView Discussions"
<nv-l AT lists.ca.ibm DOT com>
nv-l AT lists.us.ibm DOT com
[NV-L] cisco pix firewall
Running Netview 7.1.4 FP 4, AIX 5.2.. Cisco PIX 535 version 6.3
I've been tasked with creating an alert when the PIX fails over
(from primary to secondary / and vice versa). I currently have a separate
window when certain devices go down, and I also have pop-up windows when a link
down trap is received from a critical devices..
If I remember right, there is a trap that is sent when a PIX
fails over? If I can determine the right trap then I can use that to
generate a popup or email message. Is there any special configuration to
Has anyone successfully monitored a failover?
NV-L mailing list
NV-L AT lists.ca.ibm DOT com
Unsubscribe:NV-L-leave AT lists.ca.ibm DOT com
(Browser access limited to internal IBM'ers only)