RE: [nv-l] error when using the get value from mib

2005-09-21 03:18:27
Subject: RE: [nv-l] error when using the get value from mib
From: "praveen kumar" <praveenkumar.nair AT ustri DOT com>
To: <nv-l AT lists.us.ibm DOT com>
Date: Wed, 21 Sep 2005 12:49:02 +0530

Hi all,


Would any one guide me by giving me this information

1,Is it possible to monitor the tunnel status of pix version 6.3 I have not seen any mibs but was able to get the mibs for version 7 .


Thanks in advance,


From: owner-nv-l AT lists.us.ibm DOT com [mailto:owner-nv-l AT lists.us.ibm DOT com] On Behalf Of praveen kumar
Sent: Tuesday, September 20, 2005 5:55 PM
To: nv-l AT lists.us.ibm DOT com
Subject: [nv-l] error when using the get value from mib


Hi all,


I am running netview for windows 7.1.4 ,I am trying to monitor the vpn tunnel status I found out the mib from pix version 7 but I am having pix version 6.3 when I browse through this mib and try to get the value error message




 Is this because this mibs are not supported in 6.3 ,I was not able to get this mib CISCO-IPSEC-FLOW-MONITOR-MIB-V1SMI.my for pix 6.3 any thoughts to share ,it was a bit of effort to  load this mib James shanks  helped me to get this done .thanks for James .


True regards,


<Prev in Thread] Current Thread [Next in Thread>