Is it possible in ITSA to select specific ports on a switch to be status
polled? My understanding of poll_all_ports in correlator.ini is that if
you set it to no then it will only poll ports that have
NetView-discovered layer 3 devices attached, rather than polling all
ports?
What happens if those attached devices are unmanaged? Does the switch
port still get polled?
Is there any way to look at a port (ideally in the physical view but any
mechanism would do) and say "stop port monitoring on ports 1, 3 and 27",
for example. Or," stop monitoring all ports whose names start fa*".
Thanks,
Jane
--
Tivoli Certified Consultant & Instructor
Skills 1st Limited, 2 Cedar Chase, Taplow, Bucks, SL6 0EU, UK
Tel: +44 (0)1628 782565
Copyright (c) 2005 Jane Curry <jane.curry AT skills-1st.co DOT uk>. All rights
reserved.
|