[nv-l] Managing Layer-3 Switches with Switch Analyzer
2005-06-24 08:19:10
Hi,
We are using NetView 7.1.4 FP3 on windows
with Switch analyzer. We have three Enterasys Layer-3 switches. Two of
them are running in router mode and one is working on Layer2 only but has
Layer-3 IOS installed. In the initial discovery of the network the devices
were not discovered properly (they were in BadOID smartset) i manually
edited the oid_to_type and oid_to_sym files to fix the problem.
Now the problem is the Layer-2 Status
of these devices is set to "unset" when i run ovtopodump-X command,
and in the IP MAP the Layer-2 status is "Unset or unknown"
(Blued). What should i do to make them managable with Switch Analyzer?
When i forcefully set the object type to switch (BH). Then the whole topology
is disturbed. Any suggestions on how to FIX this?
Thanks in advance!
Regards,
Usman Taokeer
Si3.
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [nv-l] Managing Layer-3 Switches with Switch Analyzer,
usman . taokeer <=
|
|
|