Hey
Bernhard,
The
location of trap variables ($1, $2 etc) are dependent on the particular
trap. An easy way to find which vars are which is to generate the trap
with the popup set to $* - this will list all the variables that the trap
generates.
Regs
Colin M.
Hi !
I have a simple question :
I'm configuring the Tivoli NetView TRAPs
in my system, but I can't find in any documentation what should be :
$1, $2, $3, $4, $5, $6 ...
I just found $2 - Machine name ... but
now I need to configure ServiceDown Traps ... then I need Service name and
Service Status, etc ...
Regards, Bernhard Zanker
Jr
*********************************************************************************
This e-mail and its attachments, is confidential and is intended for the addressee(s) only. If you are not the intended recipient, disclosure, distribution or any action taken in reliance on it is prohibited and may be unlawful. Please note that any information expressed in this message or its attachments is not given or endorsed by An Post unless otherwise indicated by an authorised representative independently of this message. An Post does not accept responsibility for the contents of this message and although it has been scanned for viruses An Post will not accept responsibility for any damage caused as a result of a virus being passed on.
*********************************************************************************
|