[nv-l] Novice questions...
2005-06-08 07:10:13
Hi!
I'm relatively new to NetView (learning by doing), but am a bit confused
about how NetView actually do things.
We have a customer with NetView for
Windows (7.1.4) and I wonder how the 'Poll all nodes' works. I had 'Poll
all nodes'
checked, but set "Disable all SNMP
status polling". The result seems to be nodes going down goes undetected?
When
I turned the setting to "Set SNMP
default option to poll fors status every" x minutes. This resulted
in a lot of nodes being
detected as unavailable and were deleted
because they had been down for a longer time than indicated by the "Delete
nodes down for" setting. This is
ok, but it looks like both SNMP and ICMP polling was turned off?
Regards/hilsen, Jan Erik Hoel
Senior IT Specialist
Infrastructure and Systems Management Services
IBM Global Services, Norway
Tel. 928 38270 / Fax. 929 78270
Internet mail: jehoel AT no.ibm DOT com
|
<Prev in Thread] |
Current Thread |
[Next in Thread> |
- [nv-l] Novice questions...,
Jan Erik Hoel <=
|
|
|