Re: [nv-l] Traps from IBM SAN Volume Controller
2005-02-14 08:27:44
After you ran mib2trap did you actually run the commands that were created?
Did it complete successfully?
Paul
mlelleby AT adelphia DOT net wrote:
Good morning group-
I have been trying to configure the traps for this device as I have already
loaded the MIB, ran the mib2trap to create the addtrap commands to add the
traps from the mib into netview.
I then ran an 'event -e FMTCHG' to note the change to the trapd.conf file.
However, when the device sends a trap, it still comes in unformatted.
I have checked the trapd.conf and note that the traps taken from the mib and loaded into netview seem to be correct.
Any suggestions?
|
|
|