|
Re: [nv-l] Authentication failures coming from Netview
2004-12-31 20:19:56
Craig,
It sounds has if NetView is searching
again for the correct community name to use for the device. But if the
device is already discovered and in the xnmsnmpconf view, then it should
not be looking for the community again. There are a couple of application
in addition to netmon (polling/discovery/status) that use a community name,
snmpCollect, mib applications, and mib browser.
Is the device listed in the xnmsnmpconf
view?
Could there be another application on
same box that is also making snmp request?
Do you have a /usr/OV/conf/communitynames
file listing multiple community names?
Is the community name used for the sysUptime
request list in the community names file?
Was the community name used for sysUptime
request "public"?
Run a "netmon -a 160" and
a "netmon -a 175", then check the /usr/OV/log/netmon.trace file
for the output from commands. The option of 175 will output a listing of
all the nodes known to NetView and the polling parameters defined for the
node. Is the correct community name listed?
Is snmpCollect configured to collect
data from this node?
Mark F Sklenarik
IBM SWG Tivoli Solutions
Quality Assurance
Business Impact Management and Event Correlation
Software Quality Engineer
IBM Corporation
"Treptow, Craig"
<Treptow.Craig AT principal DOT com>
Sent by: owner-nv-l AT lists.us.ibm DOT com
12/31/2004 11:54 AM
|
|
To
| "NetView List \(E-mail\)"
<nv-l AT lists.us.ibm DOT com>
|
|
cc
|
|
|
Subject
| [nv-l] Authentication failures
coming from Netview |
|
Hi. We are running Netview 7.1.4 on AIX 5.1
with these patches:
FixPack1, IY50663, IY51641, IY52429, IY54434, IY56958, IY60528
We have some routers that send authentication failure traps denoting Netview's
IP address.
I ran a capture this morning and caught Netview using the correct community
strings for this device in all cases, except one instance. It tried
to get sysUptime 3 times with the wrong string and then switched to the
correct string.
The SNMP config is correct, and demandpolls and quicktests work correctly.
What would cause Netview to query periodically using the wrong strings?
Thanks for any help!
Craig
-----Message Disclaimer-----
This e-mail message is intended only for the use of the individual or
entity to which it is addressed, and may contain information that is
privileged, confidential and exempt from disclosure under applicable law.
If you are not the intended recipient, any dissemination, distribution
or
copying of this communication is strictly prohibited. If you have
received this communication in error, please notify us immediately by
reply email to Connect AT principal DOT com and delete or destroy all copies of
the original message and attachments thereto. Email sent to or from the
Principal Financial Group or any of its member companies may be retained
as required by law or regulation.
Nothing in this message is intended to constitute an Electronic signature
for purposes of the Uniform Electronic Transactions Act (UETA) or the
Electronic Signatures in Global and National Commerce Act ("E-Sign")
unless a specific statement to the contrary is included in this message.
|
|
|
