Re: [nv-l] TEDW & Netview
2004-09-25 12:16:10
Bhayeti,
Yes to both questions. You can
configure the tdwdaemon after installing NetVIew using the following command:
nvits_config -D <db2userid>
where db2userid is the userid for DB2
installed on NetView.
Regards,
Ed Gunnet
Product Development Support - NetView Product Integrity
Tivoli Systems - APPG Business Unit
Internet: gunnet AT us.ibm DOT com
Phone: 919-224-2189
Bhayeti <bhayeti AT yahoo DOT com>
Sent by: owner-nv-l AT lists.us.ibm DOT com
09/25/2004 07:35 AM
|
To
| netview list <nv-l AT lists.us.ibm DOT com>
|
cc
|
|
Subject
| [nv-l] TEDW & Netview |
|
Folks,
Netview 7.1.4 FP1 on AIX 5.x
Firstly, Is my understanding correct that with the
addition of TEDW support for Netview that I can
collect 'SNMP collect' information directly into a
RDBMS without having to install a TME to make use of
RIM ?
Secondly, if the above is true, can the Netview TEDW
daemon be installed/configured after Netview has been
installed or would I need to re-install Netview.
Thanks
__________________________________
Do you Yahoo!?
Yahoo! Mail - 50x more storage than other providers!
http://promotions.yahoo.com/new_mail
|
|
|