Re: [nv-l] Mib2trap error with Symantec-Sesa-Mib
2004-08-12 15:38:14
mib2trap only works on MIB files, not
on the database, so it will have to drop definitions for things which are
not fully contained in that one MIB file. If your MIB has other vendor
MIBs given in the IMPORTS section, then you can almost expect that.
But the proof is in the pudding. Did
you get an addtrap script output? Does it work when you execute it
and add traps to trapd? Then you can ignore the warning messages.
If not, then you need to capture all the messages and look
again because at least one of them is not a warning.
James Shanks
Level 3 Support for Tivoli NetView for UNIX and Windows
Tivoli Software / IBM Software Group
"Delaire, Patrick"
<delairep AT aetna DOT com>
Sent by: owner-nv-l AT lists.us.ibm DOT com
08/12/2004 03:18 PM
|
To
| <nv-l AT lists.us.ibm DOT com>
|
cc
|
|
Subject
| [nv-l] Mib2trap error with
Symantec-Sesa-Mib |
|
Has anyone on this list successfully converted
Symantec Sesa Mib using Netview Mib2trap process.
The following message is received during trap conversion:
Warning: The mib description doesn't
seem to be consistent.
Some nodes couldn't be linked under the "iso" tree.
These nodes are left:
The process proceeds to list the nodes or
trap definitions that were not applied.
I don't have a problem loading the Mib but the Mib2trap drops some node
definitions.
Thanks in advance.
Patrick
This e-mail may contain confidential or privileged information.
If you
think you have received this e-mail in error, please advise the sender
by
reply e-mail and then delete this e-mail immediately. Thank you. Aetna
|
|
|