Re: [nv-l] & sign in netmon seed file ?
2004-08-09 10:03:19
Philippe, it's a ^ not a &.
DCF Document ID: 1153918 - IBM Tivoli
NetView: Force ICMP status polling for a node
Problem Desc: For routers with
unnumbered serial interfaces netmon will automatically switch from ICMP
to SNMP status polling. Under some conditions this isn't desired. How can
I force netmon to still use ICMP polling for those nodes?
Solution: In the Seedfile Editor
enter the node under the "Exclude" section of "Enable SNMP
Status Checking".
This will add an entry with a leading
^ to the seedfile.
But be aware the under this condition
netmon can no more determine the status of the unnumbered interface(s).
Oliver
Philippe Menard/France/Contr/IBM@IBMFR
Sent by: owner-nv-l AT lists.us.ibm DOT com
09.08.2004 15:22
|
To
| nv-l AT lists.us.ibm DOT com
|
cc
|
|
Subject
| [nv-l] & sign in netmon
seed file ? |
|
All,
AIX 4.3.3 + NV 7.1.3 FP 2
I sort of remember that netmon supports entries prefixed with an &
sign to mean :
use ICMP only to determine the status of device interfaces.
I could find no contribution about this in the mailing list archives although
I'm quite sure I read something like this in the past.
Is it really the & sign ?
Best regards,
Philippe.
- - -
Philippe MÉNARD
Networking Delivery Support Center
|
|
|