Re: [nv-l] nvsecd error

2004-07-26 09:34:31
Subject: Re: [nv-l] nvsecd error
From: jason.ctr.alburger AT faa DOT gov
To: nv-l AT lists.us.ibm DOT com
Date: Mon, 26 Jul 2004 09:21:10 -0400


After some investigation, I am unable to locate any documentation detailing
the backup migration you referenced.  The man pages for serversetup weren't
very helpful for performing backups, and an online search did not yield
much.  Can you please explain how to perform the action with serversetup or
send me a link to relevant documentation?


Jason Alburger
CPDLC Engineer
Joseph Sheairs Associates, Inc.

                      George deSocio                                            
                      <desocio AT us DOT ibm.c        To:       nv-l AT 
lists.us.ibm DOT com                                                         
                      om>                      cc:                              
                      Sent by:                 Subject:  Re: [nv-l] nvsecd 
                      [email protected]                                         
                      07/23/2004 10:21                                          
                      Please respond to                                         


Possible?  Probably.

Supported? No.  Our solution will always be install on the target system.

Practical? No.  Because there are other filesystems affected by NetView
installation.  /etc/services is but one example.

The following is untested when regressing, that would be going from 7.1.3
FixPack n  to  7.1.3 base, but I think it should work.

Run a backup for migration on your current system using serversetup
Tar the resulting /usr/OV.back.v7r1 filesystem and move it over to the
target system.
Untar it on the target system.
Remove the file /usr/OV.back/v7r1/conf/ovors
Perform an upgrade install.
Install any fix packs and i-fixes  you had on source system.


George deSocio
IBM Americas Support - Distributed Network Management
Dept 46-E1ZA
IBM B660  CC109
HWY 54 & 600 Park Offices
Research Triangle Park, NC  27709

E-Mail:  desocio AT us.ibm DOT com

 jason.ctr.alburger AT faa DOT gov                                              
 Sent by: owner-nv-l AT lists.us.ibm DOT com                                    
                                                        nv-l AT lists.us DOT 
 07/23/2004 09:35 AM                                    com                
             Please respond to                                     Subject 
                   nv-l                                 [nv-l] nvsecd      

RH 7.2 / NV 7.1.3

We are currently replacing our hardware and I'm attempting to take a tar
file of all NetView files from the original hardware and drop it onto the
new hardware (which also has a different IP address).  Is this possible to
do without having to run the NV install disk on the new box?

After dropping the tarball on the new box, I've wiped out the topology
(nv6000_smit clear_topology_db_all) and ran /usr/OV/service/reset_ci.
Everything seems to run fine until I try to turn on security, after which I
cannot start the OV daemons anymore because nvsecd will not start.  It's
giving the error:

nvsecd:  The server key could not be installed.

Is what I'm attempting to do possible?

Jason Alburger
CPDLC Engineer
Joseph Sheairs Associates, Inc.

<Prev in Thread] Current Thread [Next in Thread>