Put the following in your seed file to limit discovery to what is in the
seed file.

      @limit_discovery   # Limit discovery to the contents of this seed
file.


Thanks
Alan E. Hennis
Caterpillar Inc.
Systems+Process Division
309.494.3308
hennis_alan_e AT cat DOT com


                                                                                
                                                       
                      Meyos Yemveng                                             
                                                       
                      <yemveng AT yahoo DOT ca                                  
                                                              
                      >                                                         
                                                       
                      Sent by:                                                  
                                                       
                      owner-nv-l@lists. To: netview Tivoli <nv-l AT 
lists.us.ibm DOT com>                                                     
                      us.ibm.com        cc:                                     
                                                       
                                                                                
                                                       
                                                                                
                                                       
                      05/04/2004 01:32                                          
                                                       
                      PM                  Subject:      [nv-l] Discovery        
                                                       
                      Please respond to                                         
                                                       
                      nv-l                                                      
                                                       
                                                                                
                                                       
                                                                                
                                                       



Caterpillar: Confidential Green                 Retain Until: 06/03/2004
                                                Retention Category:  G90 -
                                                General
                                                Matters/Administration




Hi Folks,
I would like to clarify some discovery issues
1- I want to limit Netview to only discover what I have in the seed file
Q1: do I need to specify what IP range not to discover again? !102.105.123.
*
Q2: What should I Do

Q3- I want to prevent unwanted Nodes to be discovered such as Nodes
detected by ICMP and SNMP Ping sweeps and SNMP Cold/Warm start Traps ?

Q4- Any other suggestions?



Thank You,
Meyos
"ALLEZ LES LIONS INDOMPTABLES"



Post your free ad now! Yahoo! Canada Personals