Re: [nv-l] Not detecting Network Failures
2004-01-06 08:06:01
Is the IP address of the interface that represents that link represented on the map? Was the outage as long as your polling cycle? The polling cycle is 5 minutes by default and is set under 'Options..SNMP Configuration'. Check in /usr/OV/log/trapd.log around the time of the outage to see what events did occur at that time. Are the events present but the map is not changing color? Is your map fully discovered, with all networks connected by lines? Netview is very good at detecting outages, usually, so I suspect that you are just experiencing some 'getting started' problems. I hope these questions will help you narrow down the definition of the problem.
Cordially,
Leslie A. Clark
IBM Global Services - Systems Mgmt & Networking
Detroit
| nraaman AT chennai.tcs.co DOT in
Sent by: owner-nv-l AT lists.us.ibm DOT com
01/06/2004 03:39 AM
Please respond to nv-l
|
To: nv-l AT lists.tivoli DOT com
cc:
Subject: [nv-l] Not detecting Network Failures
|
Hi,
We are using NetView 7.1.4 on AIX 5.1. When ever any link goes down, NetView is not
detecting the failures. The netmon is running.
Please help on this.
Regards
N.Raaman
#### InterScan_Disclaimer.txt has been removed from this note on January 06, 2004 by Leslie Clark
|
|
|