Re: [nv-l] Interface Discovery
2003-11-13 10:45:04
Have you verified that
File ---> Describe Map ---> Map Description ---> Configuration ---> How
should interface labels be shown?
is set to "Default" and not "IP Address"
Thanks
Alan E. Hennis
Caterpillar Inc.
Systems+Process Division
309.494.3308
hennis_alan_e AT cat DOT com
\
James Shanks
<jshanks AT us DOT ibm.c
om>
Sent by:
owner-nv-l@lists. To: nv-l AT lists.us.ibm DOT com
us.ibm.com cc:
11/13/2003 09:26
AM Subject: Re: [nv-l] Interface
Discovery
Please respond to
nv-l
Caterpillar: Confidential Green Retain Until: 12/13/2003
Retention Category: G90 -
General
Matters/Administration
Does your command line SNMP return the information that is missing?
James Shanks
Level 3 Support for Tivoli NetView for UNIX and Windows
Tivoli Software / IBM Software Group
reamd AT Nationwide DOT com
Sent by: To: nv-l AT lists.us.ibm DOT com
owner-nv-l AT lists.us DOT ibm.c cc: nv-l AT lists.us.ibm DOT
com,
om owner-nv-l AT lists.us.ibm DOT com
Subject: Re: [nv-l] Interface
Discovery
11/13/2003 10:17 AM
Please respond to nv-l
I have done a demand poll. I have snmp to the device. I can snmpwalk it and
it brings in the correct bitmaps when discovered. When you drill down to
see the interfaces of the router. It will show all interfaces and there
status, it just shows the interface IP address and not the interface
description.
James Shanks
<jshanks AT us.ibm DOT com> T
To:
nv-l AT lists.us.ibm DOT com
Sent by: cc:
owner-nv-l AT lists.us DOT ibm
.com bcc:
Subject:
Re: [nv-l] Interface Discovery
11/13/2003 09:24 AM
Please respond to nv-l
Have you tried a demand poll?
You won't get that information until a config poll is done: it requires
SNMP. If you have a device on the map and no information about i in the
databases, then your community string for that device is probably wrong.
James Shanks
Level 3 Support for Tivoli NetView for UNIX and Windows
Tivoli Software / IBM Software Group
reamd AT Nationwide DOT com
Sent by: To:
owner-nv-l AT lists.us.ibm DOT com nv-l AT lists.us.ibm DOT com
cc:
Subject: [nv-l]
11/13/2003 09:11 AM Interface Discovery
Please respond to nv-l
Hi All,
During discovery, netview discovers the device and interfaces.
Instead of telling what type of interface it is (FastEthernet, Serial, ect)
it gives me IP addresses. How do I change this. Thanks, Dave
Netview 7.1.3
AIX 5.1
|
|
|