|
Re: [nv-l] nvpagerd dies
2003-10-21 13:16:41
Look at errpt ( run errpt -a > myfile ) and see what else is happening around that time.
There is no error level in nvapgerd. That's an OS level message complaining about the errors.
I have only two guesses.
Is it possible that you have paging enabled but your modem or tty device is inactive? That's the only "file" (all UNIX I/O is to a "file") that might be an issue here that I can think of.
If there is no nvpager.warm file it should work fine, unless perhaps you deleted it while the daemon was active and expecting to write to it.
James Shanks
Level 3 Support for Tivoli NetView for UNIX and Windows
Tivoli Software / IBM Software Group
|
| "Bursik, Scott {PBSG}" <Scott.Bursik AT pbsg DOT com>
Sent by: owner-nv-l-digest AT lists.us.ibm DOT com
10/21/2003 12:16 PM
Please respond to nv-l
|
To: "'Nv-L (nv-l AT lists.us.ibm DOT com)'" <nv-l AT lists.us.ibm DOT com>
cc:
Subject: [nv-l] nvpagerd dies
|
NetView 7.1.3 AIX 4.3.3
I have had several instances where nvpagerd dies and when I look at the
nvpagerd.errlog I see the following message every time:
Error(/usr/OV/bin/nvpagerd): Too many consecutive child errors.
10/20/03 16:18:39 - Error(/usr/OV/bin/nvpagerd): select() failed. : A file
descriptor does not refer to an open file.
I don't see anything in the nvpagerd.alog or nvpagerd.blog that is obviously
an issue. Has anyone seen this? Is there a way of bumping up the error level
in nvpagerd?
Thanks,
Scott
|
|
|
