Re: [nv-l] how to use trapgend to capture AIX error log message
2003-07-11 09:40:22
Pierre,
Piece of cake, I just completed this same task. With NetView you are given trapgend to run on any AIX machine. Deploy this to your AIX machines and a good number, but not all messages will be caught by NetView. You can install this code via smit from your NetView machine. Alternatively you can install Service Director and use your NetView machine as the central log host. This will scrap the errpt log and call IBM when there are hardware problems. The trapgend solution is excellent, I have found several problems once the code was installed. Hats off to the NetView folks for trapgend.
My only beef is there should a an installp or rpm procedure as an alternate installation method. I found a bare bones method written by James Shanks of IBM. Anyway I plan on cobling together a RPM install of the code.
Regards,
Jim
Jim Horwath
Guardian
IT Unix Services
610-807-8795
To: "Nv-L (E-mail)" <nv-l AT lists.tivoli DOT com>
cc:
bcc:
Subject: [nv-l] how to use trapgend to capture AIX error log message
Hi!
I need to trap AIX error log message in my Netview. Anybody know how I can
do that ? If your answer is errpt command, can you explain how it works
Regard!
_
Pierre Jr Racine
Technocentre National
Télécommunications & Multimédia
Tél.: (418) 527-5211 ext: 5282
Email: junior AT ssss.gouv.qc DOT ca
Site Web: http://www.sogique.qc.ca
---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe AT lists.tivoli DOT com
For additional commands, e-mail: nv-l-help AT lists.tivoli DOT com
*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)
|
|
|