|
Hi
listers,
Environment:
AIX
5.1
NetView
7.1.3
Switch Analyzer
1.2
How is NetView and
Switch Analyzer supposed to properly display a configuration of a switch on a
map? According to the SA documentation, SA creates a network segment for
each port to represent a connection between the port and the devices connected
directly to it.
For some reason,
NetView discovered the device properly as a switch and shows the one IP
connection. Then the switch shows a connection to 1 segment, however at
least 5 ports are being used on the switch. How do I get this to
display properly on the map?
I did conduct a
Demand Poll from NetView and it did see all the ports (told me they had no IP
addresses). Then I ran the ovtopodump -X command and got the following
(the device is being recognized on the SA side):
Node ID
Object
IP Status L2 Status IP
Address SNMP
OID
Layer 2 OID?
734
10.249.32.164
Up
Unset 10.249.32.164
1.3.6.1.4.1.9.1.287
Yes
Any assistance would
be appreciated.
Thanks,
Scott
Scott
Hammons
Senior Consultant
Advanced Integrated
Solutions, Inc.
| 