colmaint -d <filename> will create a file with the smartsets. I recommend 
clearing topology on the new box, issuing the colmaint -d to create a smartset 
file, then move the file to the new box and do a colmaint -l <filename> to load 
the smartsets back in. It has been my experience that moving the smartsets 
after discovery is kind of quirky.

-----Original Message-----
From: Jeffrey G. Fitzwater [mailto:jfitz AT Princeton DOT EDU]
Sent: Tuesday, February 11, 2003 1:45 PM
To: NVmailinglist
Subject: [nv-l] moving SMARTSETS


Netview 7.1.3
Sol 2.8

I am setting up new NETVIEW host and want to move certain pieces over.
What is the best way to copy SMARTSETs from one machine to another?


Jeff Fitzwater
OIT Systems & Networking
Princeton University


---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe AT lists.tivoli DOT com
For additional commands, e-mail: nv-l-help AT lists.tivoli DOT com

*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)


---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe AT lists.tivoli DOT com
For additional commands, e-mail: nv-l-help AT lists.tivoli DOT com

*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)