It doesn't look like a NetView trap to me.
I suggest you start a trapd trace and see who sent it (the IP address will 
be given in the trace).

You didn't mention whether you are using the NT product or the UNIX one, 
which is always a good idea when you are asking for help.
To start the trace in UNIX you should first have trapd running with "-x" 
option, which you can set in serversetup -- it's the "hex dump all 
packets" option for trapd.  Once trapd is running with that option you can 
toggle the trace on and off at the command line using the command, "trapd 
-T".  If you are using NT, then you have to set up the trace outside of 
the serversetup routine as there is no option for it.  You would add "-t 
\usr\OV\log\trad.trace" to the options trapd runs with.  You could do that 
by editing \usr\ov\conf\ovsuf directly, or doing it the documented way in 
\usr\ov\lrf\trapd.lrf  and then using first "ovdelobj 
C:\usr\ov\lrf\trapd.lrf" command to remove the old trapd definition and 
then  "ovaddobj  C:\usr\ov\lrf\trapd.lrf" to add the new one.

Hope this helps 

James Shanks
Level 3 Support  for Tivoli NetView for UNIX and NT
Tivoli Software / IBM Software Group




colin.quadros AT citicorp DOT com
09/09/2002 12:53 AM

 
        To:     nv-l AT lists.tivoli DOT com
        cc: 
        Subject:        [nv-l] Trap from 0.0.0.0 

 

I am getting a trap with the source address as 0.0.0.0

"Node 0.0.0.0 is ReInitialized Due to power-on at 09/08/02_07:18:29 AM".

All my routers are having proper IP addresses configured.
What could be causing this kind of a trap.

Regards
Colin.


---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe AT lists.tivoli DOT com
For additional commands, e-mail: nv-l-help AT lists.tivoli DOT com

*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)