Have you looked at RFC1213?  That is where I got all of my information.

www.rfc.net

Also, it helps to walk the mib tree for a device to get some basic values to
make sure you are looking at the correct MIBs as well as the correct
interface (sub-interfaces).

Jason Allison
Principal Engineer
ARINC Incorporated
Office:  (410) 266-2006
FAX:  (410) 573-3026


-----Original Message-----
From: Enriquez,C-Raul,MEXICO,INFO [mailto:C-Raul.Enriquez AT MX.NESTLE DOT com]
Sent: Wednesday, May 08, 2002 8:59 AM
To: 'Netview List'
Subject: [nv-l] Bandwidth utilization


Hello list:

I´m doing an analysis regarding the bandwith utilization in my network to
get some graphics, currently I have information from my serial links, but
I'm trying to get information from the LAN ports of the AS/400 and I don't
get any data. 
I'm reading MIB variables IfSpeed, IfInOctects and IfOutOctects but I don't
get any information.

Any idea???

Thanks. Regards.

Carlos Enriquez
Systems Analyst
IS/Technical Support
Nestle Mexico, SA de CV
Phone: (52)55-5262-5546
email: c-raul.enriquez AT mx.nestle DOT com
Welcome to:http://intranet.nestle.mx/informatica/



---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe AT lists.tivoli DOT com
For additional commands, e-mail: nv-l-help AT lists.tivoli DOT com

*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)