Re: [nv-l] addtrap parameter
2002-04-15 10:16:37
These are different ways to format the variable in trapd.conf. They are
explained in the trapd.conf man page. The variable format specifies how
the variable is shown in the Log Message. If you still do not understand
what the man page says, then why not play with it for some specific trap?
If you have an snmptrap script which sends some trap, then play with that
one. If not, use the event command with a dummy node. For example,
event -h dummy1
will send a Node Up trap with a hostname of "dummy1"
event -e NDWN_EV -h dummy1
will send a Node Down trapd with hostname of "dummy1" and
event -e ?
will show you all the traps that the event command can generate
When you are finished experimenting you can always put the Log Message
back the way it was.
James Shanks
Level 3 Support for Tivoli NetView for UNIX and NT
Tivoli Software / IBM Software Group
"D'Apice, Dominic" <D.D'Apice AT SAQ.qc DOT ca>
04/15/2002 09:55 AM
To: "Netview - List (E-mail)" <nv-l AT lists.tivoli DOT com>
cc:
Subject: [nv-l] addtrap parameter
Hello ALL, aix 4.3.3 and nv 7.1
in addtrap :
what the difference between : $n, $-n an $+n ?
also what mean this parameter : $%n
thankyou
> Dominic D'Apice
> * D.D'Apice AT saq.qc DOT ca
>
>
---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe AT lists.tivoli DOT com
For additional commands, e-mail: nv-l-help AT lists.tivoli DOT com
*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)
|
|
|