NetView will use as subnet mask, whatever the SNMP agent on the target
device says. I have seen one or two devices in the past where there
has been disagreement between the device's config, as shown by telnet,
and what the device's SNMP agent is reporting. What's the beastie
I know no way of "fooling" NetView about subnetmasks....
sabirali sama wrote:
anyone advise me, I have discovered a device on the network and it is showing
up on the map, with a Subnet mask of 255.255.255.0, however the device
is configured with a subnet mask of 255.255.255.192 when we telnet to the
device and check its' configuration. The client has advised me that there
are a few illegal subnets on the network.Can
NetView be configured such that NetView sees the device with a subnet mask
of 255.255.255.192 and if so is this will this change result in the product
being not supported by Tivoli?Many
thanks in advance for any help.Sabirali
Tivoli Certified Consultant & Instructor
Skills 1st Limited, 2 Cedar Chase, Taplow, Bucks, SL6 0EU, UK
Tel: +44 (0)1628 782565
Copyright (c) 2002 Jane Curry <jane.curry AT skills-1st.co DOT uk>.
All rights reserved.