nv-l

Rulesets

2002-01-07 16:43:43
Subject: Rulesets
From: "CATALINA MARTINEZ" <CATALINA.MARTINEZ AT tlc.state.tx DOT us>
To: nv-l AT lists.tivoli DOT com
Date: Mon, 07 Jan 2002 15:43:43 -0600
This is a MIME message. If you are reading this text, you may want to 
consider changing to a mail reader or gateway that understands how to 
properly handle MIME multipart messages.
Hello All,

Running AIX 4.3.3 Netview 6.0.2

I created a ruleset that will execute a script (for a traceroute) if it 
receives 3 sets of Nodes UP/DOWN from a node found in a Smartsets. When the 4th 
node down is received (before the 4th node up), execute the script.

On occassions, we get Node UP/DOWN from routers (frame relay). So I have been 
told to monitor these routers and when the problem starts, capture the data 
from a traceroute. The problem seems to be (right now) only one router and it 
occurs everytime Netmon goes through its polling cycle. So every 5 min, we get 
a set of Interface down, node down, interface up, node up. 

I have a smartset with all the routers (in question)are in it. The ruleset I 
created is a follows (which is not working):
event--> trap Node Down Input 1 ―> trap Node up Input 2 ―> reset on match ―> 
query smartset (wan routers) ―> threshold 3 / 1 hr ―> action

I suppose I could do it for a particular node (for example, the one in question 
right now) by using the Event Attributes but I really would like to have it set 
up for that particular Smartset.

Any suggestions...
Hello All,
 
Running AIX 4.3.3 Netview 6.0.2
 
I created a ruleset that will execute a script (for a traceroute) if it receives 3 sets of Nodes UP/DOWN from a node found in a Smartsets. When the 4th node down is received (before the 4th node up), execute the script.
 
On occassions, we get Node UP/DOWN from routers (frame relay). So I have been told to monitor these routers and when the problem starts, capture the data from a traceroute. The problem seems to be (right now) only one router and it occurs everytime Netmon goes through its polling cycle. So every 5 min, we get a set of Interface down, node down, interface up, node up.
 
I have a smartset with all the routers (in question)are in it. The ruleset I created is a follows (which is not working):
event--> trap Node Down Input 1 —> trap Node up Input 2 —> reset on match —> query smartset (wan routers) —> threshold 3 / 1 hr —> action
 
I suppose I could do it for a particular node (for example, the one in question right now) by using the Event Attributes but I really would like to have it set up for that particular Smartset.
 
Any suggestions...




<Prev in Thread] Current Thread [Next in Thread>
  • Rulesets, CATALINA MARTINEZ <=