If that is a newer type Cisco switch, the CPU never even moves off of zero.
All the switch work is done at hardware layer there is virtually no CPU. If
this is an older layer 3 switch, then CPU consideration is probably in
order.

-----Original Message-----
From: Maxime TRANNOY [mailto:MTRANNOY AT fr.ibm DOT com]
Sent: Thursday, November 22, 2001 8:48 AM
To: IBM NetView Discussion
Subject: [NV-L] Data collection & Threshold



Hi,

I would like to put a threshold on the CPU mib variable of one of my
switch.
I know that it's possible to see if the variable is over 90% and to send a
trap when this threshold is reach.
The problem is that i want only to be warn when this OID is higher than 90%
during 5 min.

Is it possible to do such a thing whith netview?

Kind regards/Cordialement.

Maxime TRANNOY
IGS - Network Delivery Support Center
Tel : +33 (0) 492 114 767
mailto:mtrannoy AT fr.ibm DOT com