What do your rulesets look like?  Rulesets run out of ESE.automation should
have the initial event stream node set to BLOCK (not PASS) and they should
not contain a Forward or Resolve node.  This has been a subject on this
forum several times.
Perhaps you might want to search the archives  for a rather lengthy post I
made several times on ruleset performance and what not to do in them.

James Shanks
Level 3 Support
Tivoli NetView for UNIX and NT
Tivoli Software
IBM Software Group
Please note that my new id is jshanks AT us.ibm DOT com




                                                                                
                  
                    anand anupam                                                
                  
                    <ananda@bharatpetr       To:     IBM NetView Discussion 
<nv-l AT tkg DOT com>        
                    oleum.com>               cc:                                
                  
                    Sent by:                 Subject:     [NV-L] Rule set stops 
working on its    
                    owner-nv-l AT tkg DOT com        own                        
                         
                                                                                
                  
                                                                                
                  
                    10/17/01 12:46 AM                                           
                  
                    Please respond to                                           
                  
                    IBM NetView                                                 
                  
                    Discussion                                                  
                  
                                                                                
                  
                                                                                
                  



Hi All,

We are having 6.0.1 on AXI 4.3.3

We are having couple of rulesets mainly for forwarding email alerts through
perl scripts. These rulesets we are envoking through ESE.automation file.

Problem is, sometimes some of the rulesets stops working on its own. I have
seen the  nvaction.alog file where all the rulesets are getting registered
and I am not getting any error message there.

 I have also checked trapd.log where netmon traps are prsent but no mails
were initiated through rule sets.

Surprisingly, after doing ovstop and ovstart some of the rulesets start
working BUT NOT ALL.

Also, The ruleset not working now were working some day back.

Please suggest me where I should look into what would be the possible cause
?

Thanks in advance,

Regards,

Anupam