Maxime, I am not certain what you mean by '2 layer switch', but I would
guess that you mean it is not drawn as a router. Is VRRP similar to
Cisco's HSRP? That is what the % is for. It is for addresses that move
back and forth between two different devices, and that address does NOT
appear in the address table of either device.

Can you please rephrase your question and use a lot more words?

Cordially,

Leslie A. Clark
IBM Global Services - Systems Mgmt & Networking
Detroit


                                                                                
                  
                    Maxime                                                      
                  
                    TRANNOY/France/Contr       To:     IBM NetView Discussion 
<nv-l AT tkg DOT com>      
                    /IBM@IBMFR                 cc:                              
                  
                    Sent by:                   Subject:     [NV-L] Problem with 
VRRP              
                    owner-nv-l AT tkg DOT com                                   
                         
                                                                                
                  
                                                                                
                  
                    10/11/01 03:53 AM                                           
                  
                    Please respond to                                           
                  
                    IBM NetView                                                 
                  
                    Discussion                                                  
                  
                                                                                
                  
                                                                                
                  




I have problemwith VRRP on Netview.

I have 2 accellar routeur which are Running VRRP.

Netview discover the first one as a routeur and the second one as a 2 layer
switch.
I put in my seed file the % in front of the Virtual VRRP IP adress but
Netview discover the VRRP adress like a 2 layer switch.

I want that Netview see the Virtual adress as a routeur and the 2 other
address as 2 layer switch.

How can i do that.( i thought i have to use % to do that)


Best regards/Cordialement.

Maxime TRANNOY
IGS - Network Delivery Support Center
Tel : +33 (0) 492 114 767
mailto:mtrannoy AT fr.ibm DOT com



_________________________________________________________________________
NV-L List information and Archives: http://www.tkg.com/nv-l