James,

I should have looked there..., there was an snmp entry with port 50161.
Changed it, SNMP queries are OK now.

Thanks,

Bernard

At 12:23 07-09-2001 -0400, you wrote:
>That should have been, "What is in  C:\WINNT\system32\drivers\etc\Services
>?"
>
>James Shanks
>Level 3 Support
>Tivoli NetView for UNIX and NT
>Please note that my new id is jshanks AT us.ibm DOT com
>
>
>
>James Shanks/Raleigh/IBM@IBMUS AT tkg DOT com on 09/07/2001 11:46:13 AM
>
>Please respond to IBM NetView Discussion <nv-l AT tkg DOT com>
>
>Sent by:  owner-nv-l AT tkg DOT com
>
>
>To:   IBM NetView Discussion <nv-l AT tkg DOT com>
>cc:
>Subject:  Re: [NV-L] Why is NetView using port 50161
>
>
>
>What is in C:\WINNT\system32\drivers\etc ?
>
>James Shanks
>Level 3 Support
>Tivoli NetView for UNIX and NT
>Please note that my new id is jshanks AT us.ibm DOT com
>
>
>
>Bernard Disselborg <bdisselb AT triple-p DOT nl>@tkg.com on 09/07/2001 
>11:18:40 AM
>
>Please respond to IBM NetView Discussion <nv-l AT tkg DOT com>
>
>Sent by:  owner-nv-l AT tkg DOT com
>
>
>To:   IBM NetView Discussion <nv-l AT tkg DOT com>
>cc:
>Subject:  [NV-L] Why is NetView using port 50161
>
>
>
>Hello,
>
>I've installed NetView 6.0.2 on a NT 4.0 Sp6a machine.
>The problem I have is, I can only get SNMP values of the NetView machine.
>On any other node I get a timeout error message. They are supporting SNMP
>and I am using the correct community strings.
>
>Sniffing on the network I found that NetView is sending SNMP requests using
>port 50161 in stead of 161.
>
>Why is this ?
>Can this be (re)configured somewhere ?
>
>Thanks in advance,
>
>Bernard
>
>_________________________________________________________________________
>NV-L List information and Archives: http://www.tkg.com/nv-l
>
>
>_________________________________________________________________________
>NV-L List information and Archives: http://www.tkg.com/nv-l
>
>
>_________________________________________________________________________