Hi all,

after my NetView installation there was apparently not
a single Cisco trap definition in trapd.conf.

I loaded 33 Cisco MIBs for Cat6509. The way to load
trap definitions into NetView is using
mib2trap <mibfile> <outputfile> , then executing <outputfile>...

The thing is, the MIB must contain trap definitions which
I thought are entries containing the word 'TRAP-TYPE' (right?).
So I grep'ed all 33 MIB files for 'TRAP-TYPE': only 1 of the 33
Cisco MIBs contained trap definitions, that is BRIDE-MIB.my ,
which I couldn't load using the mib2trap method above.


Question:
how can I possilby load Cisco traps for CAT6509?

Thanks a lot in advance!







_________________________________________________________________