In the Event Configuration dialog for the event in question, open the 'T/EC
Slot Mapping'
dialog and add, delete, or change any slot you want.

Cordially,

Leslie A. Clark
IBM Global Services - Systems Mgmt & Networking
Detroit


                                                                                
          
                    SPENDLM@nation                                              
          
                    wide.com             To:     nv-l AT tkg DOT com            
                 
                    Sent by:             cc:     BAKERD16 AT nationwide DOT 
com,                 
                    owner-nv-l@tkg        BARGERS AT nationwide DOT com         
                 
                    .com                 Subject:     [NV-L] NetView to TEC 
interface     
                                                                                
          
                                                                                
          
                    08/20/01 07:36                                              
          
                    AM                                                          
          
                    Please respond                                              
          
                    to IBM NetView                                              
          
                    Discussion                                                  
          
                                                                                
          
                                                                                
          



Hi All,

    I would like to find out about changing the status=CLOSED slot that
NetView sends to TEC.

The 1st event below has a different sub_origin IP number than the 2nd, so
it isn't the same problem.  This is why I need either the event to arrive
without the status=CLOSED or the 3 sets of extraneous numbers in sub_origin
removed.  I changed the definitions in TEC to not compare on the sub_origin
field due to the changing value of the 1st set of extraneous numbers, but
the origin and name field aren't enough to handle the match.  The below
examples match on the hostname and origin fields, but they have a different
sub_origin IP value.

Is there a simple way in netview to change the status=CLOSED to
status=OPEN..


1~20063~1~997877788(Aug 15 08:16:28 2001)
### EVENT ###
OV_IF_Down;source=nvserverd;sub_source=N;origin=10.x.x.x;hostname=Remote
Router;adapter_host=netview server;categ
ory=2;date="08/15/01 08:28:28";severity=CRITICAL;status=OPEN;msg="Interface
Serial0.1 down.";OV_status=1;sub_origin="10.
x.x.x 997878508 14932666 14932665";END

### END EVENT ###
PROCESSED


1~20061~1~997877746(Aug 15 08:15:46 2001)
### EVENT ###
OV_IF_Down;source=nvserverd;sub_source=N;origin=10.x.x.x;hostname=Remote
Router-AGEN;adapter_host=netview server;categ
ory=2;date="08/15/01 08:27:46";severity=CRITICAL;status=OPEN;msg="Interface
Ethernet0 down.";OV_status=1;sub_origin="10.
x.x.x 997878466 14932666 14932832";END

### END EVENT ###
PROCESSED


<<< thx >>>



_________________________________________________________________________
NV-L List information and Archives: http://www.tkg.com/nv-l