Re: ESE.automation file
2001-03-08 08:36:39
After I make changes to the ESE.automation file, what daemons should
I restart for the changes to take effect? I was thinking the nvcorrd and the
actionsvr daemons? Thanks.
James_Shanks AT tivoli DOT com
03/07/2001 08:44 AM
Please respond to IBM NetView Discussion
<nv-l AT tkg DOT com>@SMTP@Exchange
To: IBM NetView Discussion <nv-l AT tkg DOT com>@SMTP@Exchange
cc:
Subject: Re: [NV-L] ESE.automation file
Yes, but these rules are run in the background by actionsvr. They
do not
affect the events display, unless you have an action in them which
is
issuing its own new traps using snmptrap. The main purpose here if
for
rulesets that do things like paging, or writing stuff to a file, and
such
things as you want to happen all the time, whether anyone has a GUI
up or
not. Such rulesets don't have "Forward" or "Resolve" in the them
because
they don't send events to a window. And such rulesets have the
initial
Event Stream node set to "block" rather than "pass" to prevent any
unintentional forwarding.
James Shanks
Team Leader, Level 3 Support
Tivoli NetView for UNIX and NT
Scott.Bursik AT fritolay DOT [email protected] on 03/07/2001 09:27:32 AM
Please respond to IBM NetView Discussion <nv-l AT tkg DOT com>
Sent by: owner-nv-l AT tkg DOT com
To: nv-l AT tkg DOT com
cc:
Subject: [NV-L] ESE.automation file
NetView 6.0.1 AIX 4.3.3
So am I to understand that I can have more than 1 rule active if I
start it
from
the ESE.automation file and pay attention to the special rules of
that
file?
Scott Bursik
_________________________________________________________________________
NV-L List information and Archives: http://www.tkg.com/nv-l
_________________________________________________________________________
NV-L List information and Archives: http://www.tkg.com/nv-l
|
|
|