Hi all

I'm using Netview to collect the if%InErrors mib expression on a Cabletron
SSR2000 (switch router).

(For those who don't remember, this expression comes ready for use with
Netview.)

I'm getting values as high as 15 % for this device, and so my question is:

Is this value ok ? Is this a simptom of a problem with the device ? What
might be causing that ?
I was hoping to see values around 2%, which is much lower than i'm getting.

Any info about the subject is welcome... Thanks

Carlos Eduardo Madruga
Advisory IT Specialist - IBM Brazil
MCP,  Tivoli Certified Consultant
Tel.: ++ 55 11 30502618
Fax.: ++ 55 11 30505947