Re: netview doesn't change status of active/non-active devices!

2000-11-13 08:03:31
Subject: Re: netview doesn't change status of active/non-active devices!
From: "Leslie Clark/Southfield/IBM" <lclark AT us.ibm DOT com>
To: nv-l AT lists.tivoli DOT com
Date: Mon, 13 Nov 2000 08:03:31 -0500
First, make sure netmon is running, and hasn't died. Then check to see
if it has fallen far behind. You can do this with 'netmon -a 3'  (for
pinging list)
and 'netmon -a 4' (for configuration polling list) on unix. It puts a
report in
/usr/OV/log/netmon.trace that shows what it is doing. If it is too busy to
that's a clue too. A wild guess is that it is being slowed down by poor
name resolution. An ovotopofix removed all of the hints and partial nodes,
but now those are back and netmon is trying to look up the names of those
hints, and going very slowly. You can see this if you turn on tracing at
of netmon.


Leslie A. Clark
IBM Global Services - Systems Mgmt & Networking

Sebastian.Szumczyk AT natned.com DOT [email protected] on 11/13/2000 07:33:42 AM

Please respond to IBM NetView Discussion <nv-l AT tkg DOT com>

Sent by:  owner-nv-l AT tkg DOT com

To:   nv-l AT tkg DOT com
Subject:  [NV-L] netview doesn't change status of active/non-active

one more thing,
netview reported that one device is not reachable so it changed color for
that device (from green to red). after node is connecting to network
properly (test ping works) netview can't change status of that device
non-active!). when i would like to poll it manually i can't (netview
respond for that:-( ). i wrote that problem with manual polling is solved,
but unfortunately it isn't:-(.
do you mind if i ask you for help?

NV-L List information and Archives: http://www.tkg.com/nv-l

<Prev in Thread] Current Thread [Next in Thread>