Re: Cisco 4000
2000-07-18 00:43:40
Well, it should not matter what kind of device it is. It only matters what
interface
information the snmp agent on that device reports. So if you have the node
on the map, try Monitor..MIB Values...Interface Info, and Monitor..Network
Configuration...Addresses. Do you have snmp access to the device.
What version of Netview are you on? There was some discussion here
recently of 5.1 having some trouble with some kinds of ATM interfaces on
a couple of Cisco models, and 5.1.2 seemed to cure it.
Cordially,
Leslie A. Clark
IBM Global Services - Systems Mgmt & Networking
Detroit
Marcelo Pastre <mpastre AT power.ufscar DOT br>@tkg.com on 07/17/2000 01:15:24
PM
Please respond to IBM NetView Discussion <nv-l AT tkg DOT com>
Sent by: owner-nv-l AT tkg DOT com
To: IBM NetView Discussion <nv-l AT tkg DOT com>
cc:
Subject: [NV-L] Cisco 4000
Hi folks....
I can't see Cisco 4000 Router Interfaces with Netview for AIX.
How do I do that?
Thanks,
Marcelo.
_________________________________________________________________________
NV-L List information and Archives: http://www.tkg.com/nv-l
|
|
|