That did work but when I ran the command colmaint -l on machine2 it
said it could not connect to database. So I restarted the daemons and ran
the command. It then worked, but it did not update the map. I ran the
smit command to fix database problems and now the map is updated with the
smartsets. If I had just restarted the right daemon instead of all of
them, when I started the GUI it probablly would have been there.
Schiffinger Ralph 2100
<[email protected] To: "'IBM NetView
Discussion'" <nv-l AT tkg DOT com>
Sent by: Subject: AW: [NV-L]
Moving SmartSets from 1 box to another
owner-nv-l AT tkg DOT com
06/20/00 10:48 AM
Please respond to IBM
just run "colmaint -d" on machine1.
default output goes to /usr/OV/conf/collection.conf
copy this to machine2.
exit all GUI's, stop all daemons.
then run "colmaint -l" on machine2.
restart daemons, restart GUI - bingo.
HTH, cordially, Ralph.
iT-AUSTRIA / OE2100 / TK-NWM
Tel (mobil) 0664 1908469
Tel (iT-A) 21717 58948
FAX (iT-A) 21717 58979
Mailto:Ralph.Schiffinger AT erstebank DOT at
> -----Urspr> üngliche Nachricht-----
> Von: ronnie.ross AT SPRINGS DOT COM [SMTP:ronnie.ross AT SPRINGS DOT COM]
> Gesendet am: Dienstag, 20. Juni 2000 16:00
> An: IBM NetView Discussion
> Betreff: [NV-L] Moving SmartSets from 1 box to another
> Is there a way to move SmartSets from 1 NetView to another NetView?
> tried nvUtil G to list all SmartSets with the rule and piped this to a
> and tried to run this into the nvUtil a to add it back in but it did not
> like it.
> Thanks for the help.
> Ronnie Ross
> Network Engineer
> NV-L List information and Archives: http://www.tkg.com/nv-l
NV-L List information and Archives: http://www.tkg.com/nv-l