Re: Rule set

2000-06-15 13:15:28
Subject: Re: Rule set
From: James_Shanks AT tivoli DOT com
To: nv-l AT lists.tivoli DOT com
Date: Thu, 15 Jun 2000 13:15:28 -0400
Bring up your ruleset in the ruleset editor again and click on the Event Stream
(the "purple pizza") and see whether it set to BLOCK or to PASS.  If PASS all
events will be forwarded unless you specifically block them later.  I'll bet
that's it.  You should set the Event Stream to BLOCK in this case so that
nothing gets through unless you Forward it.

James Shanks
Team Leader, Level 3 Support
 Tivoli NetView for UNIX and NT

"Patel, Shaileshbhai B" <shaileshbhai.patel AT eds DOT com> on 06/15/2000 
12:41:56 PM

Please respond to IBM NetView Discussion <nv-l AT tkg DOT com>

To:   "NV-L Discussion (E-mail)" <nv-l AT tkg DOT com>
cc:    (bcc: James Shanks/Tivoli Systems)
Subject:  [NV-L] Rule set

Hello  Everybody,

     I am trying to create a rule set for forwarding only specific events
from NetView to T/EC. Problem is that it still forwards all of events from
NetView. I would like to know that what node operator I should use in rule
set editor so that I can develop a logic that forward only these events. The
way I have created rule set right now is

      Event Stream --->-Trap Setting--->-Forward
                                  ---->Trap Setting--->Forward

Trap setting nodes for all of events that I want to forward to T/EC.

Thanks in advance

Shailesh Patel
Enterprise Management Services
Electronic Data Systems
Troy MI 48098
(248) 265-7573

NV-L List information and Archives: http://www.tkg.com/nv-l

<Prev in Thread] Current Thread [Next in Thread>
  • Rule set, Patel, Shaileshbhai B
    • Re: Rule set, James_Shanks <=
    • RE: Rule set, Patel, Shaileshbhai B