Re: NetView for NT

2000-05-24 11:59:41
Subject: Re: NetView for NT
From: Bill_Jameson AT tivoli DOT com
To: nv-l AT lists.tivoli DOT com
Date: Wed, 24 May 2000 11:59:41 -0400
Frank,  This was found during verification testing and fixed on NV 6.0.
You didn't state the level of NV you are running.  Following is what causes the
and maybe you can set the client password to match the server and get around
your problem.

"The problem was that the NetView account on the client did not get the
correct password set.  You can verify that by setting the client NetView
account's password to the same as the server's NetView account password."

"Focus on remedies, not faults."

Bill Jameson
Tivoli Systems

"Frank W. Hansen" <fhansen AT enterpriseinnovations DOT com> on 05/24/2000 
01:08:21 AM

Please respond to IBM NetView Discussion <nv-l AT tkg DOT com>

To:   nv-l AT tkg DOT com
cc:    (bcc: Bill Jameson/Tivoli Systems)
Subject:  [NV-L] NetView for NT

Greetings.  I have a situation that I believe was posted before.  My
environment is a NetView server running on NT 4.0 SP 4 and NetView clients
running on NT Workstation 4.0 SP 4.  From a NetView client I try to issue a
demand poll and receive "Waiting for netmon daemon to respond...".  When I
look at the nv.log file on the NetView server I see "CreateFile on pipe
"\\servername\pipe\demand.111" failed. Error: The network path was not
found."  I check the obvious.  Host lookups both forward and reverse on both
the client and server and all checks out.  I can manually map a drive share
from the server to the client and vise versa so I'm stumped.  Any ideas?

Best Regards,

Frank W. Hansen
Enterprise Certified Tivoli Consultant


NV-L List information (unsubscribing, policies, posting, digest version,
searchable archives): http://www.tkg.com/nv-l

<Prev in Thread] Current Thread [Next in Thread>