I didn't understand what you say in the last e-mail...
I haven't experience with NetView.
There are some description in the NetView Administrator's manual that i
don't understand the meaning this for my network, ie. ,
If this event is god or bad or irrelevant or implicate something, understand...
I need to learn, ok!!!!
>I don't understand what you are asking. Is there some part of my append you
>did not understand?
>You look on the event card for this event. It will tell you the specific id
>number ( I think it is 58982401, but you should check). With this information
>you go the NetView Administrator's manual, to the Appendix, and look up the
>description of this event. That's where the meaning of this event is given.
> The same information, although abbreviated if it is very long, should
> appear in
>the DESCRIPTION section of trapd.conf where this event is defined. So if you
>don't have the book handy, or don't want to bring up the on-line books,
>get some idea of what this trap means by bringing up xnmtrap and looking
>description for this event.
>If this doesn't help, please try to explain again what you are looking for. I
>don't know what else to tell you.
>Tivoli (NetView for UNIX and NT) L3 Support
>Marcelo Pastre <mpastre AT POWER.UFSCAR DOT BR> on 03/02/2000 12:30:06 PM
>Please respond to Discussion of IBM NetView and POLYCENTER Manager on NetView
> <NV-L AT UCSBVM.UCSB DOT EDU>
>To: NV-L AT UCSBVM.UCSB DOT EDU
>cc: (bcc: James Shanks/Tivoli Systems)
>Subject: Re: Understanding the History Event's messages!!!
>Ok thanks, but where find documentation about this messages???
> >Marcelo -
> >All NetView traps are documented in at least 2 places -- in trapd.conf,
> >you can view by using xnmtrap from the command line or by pulling down the
> >Options menu and selecting Event Configuration, and in the Appendix to the
> >NetView Administrator's Guide, which you should have received in hard
> copy but
> >you can also consult on -line by typing in "dtext" from the command line or
> >using Help from the GUI.
> >This particular trap can have several causes, but basically it is issued
> >of link-level address mismatches. This can happen if some nodes are on
> >and some on token ring, because these media report addresses differently,
> >or it
> >could be a more serious routing problem. Basically, I would configure the
> >"ignore" option ring bit swapping errors for netmon as the documentation
> >suggests and see if the these traps disappear.
> >James Shanks
> >Tivoli (NetView for UNIX and NT) L3 Support
> >Marcelo Pastre <mpastre AT POWER.UFSCAR DOT BR> on 03/01/2000 07:03:41 PM
> >Please respond to Discussion of IBM NetView and POLYCENTER Manager on
> > <NV-L AT UCSBVM.UCSB DOT EDU>
> >To: NV-L AT UCSBVM.UCSB DOT EDU
> >cc: (bcc: James Shanks/Tivoli Systems)
> >Subject: Understanding the History Event's messages!!!
> >I would like to find more informtaion about these History Event's
> >Something which show what mind these messages because i don't
> >for example, what mind "link address reported diferent by 22.214.171.124