Yes, you need to pull all the affected areas out of the ODM, deleted the
duplicate areas and re-write to the ODM. I would advise a good backup first,
just in case.

Steve Thornhill - IBM ETC
Int       - 255104
Ext      - 01705 565104
Mob   - 0378 289770
Email - steve_thornhill AT uk.ibm DOT com


"MENEZES, ALAIN" <alain.menezes AT FORTISBANK DOT COM> on 09/12/99 14:43:15

Please respond to Discussion of IBM NetView and POLYCENTER Manager on NetView
      <NV-L AT UCSBVM.UCSB DOT EDU>

To:   NV-L AT UCSBVM.UCSB DOT EDU
cc:    (bcc: Steve Thornhill/UK/IBM)
Subject:  double entries in SMIT




Hi all,

I installed TME 10 NetView twice in a row on an AIX system : SMIT now shows
two entries for each item regarding NetView.
Is there any way I could get into RODM and correct this ?
(This is a test machine so even unsupported procedures are welcome : bad
comes to the wors, I could scratch the whole thing down!)

Thanks

Al