If you look into Mid Level Managers users guide (Hard Copy) on page 9-62, it
clearly stats that it will generate multiple results for each interface if
you use wild card. And I am getting value for each interface on the router.
Any other suggestions?
Thanks for the response.
> -----Original Message-----
> From: Leslie Clark [SMTP:lclark AT US.IBM DOT COM]
> Sent: Tuesday, December 07, 1999 11:28 PM
> To: NV-L AT UCSBVM.UCSB DOT EDU
> Subject: Re: APM
> I'm not sure, but I seem to recall that expressions and wildcard instances
> mix. Have you tried this with a specific interace instance? I know that if
> you were
> monitoring something like filesystem utilization, and used *, it would
> for any instance, but I'm not sure it behaves the same way when there is
> expression involved. You may have to monitor them separately.
> Anybody else? I'm reaching way back here...
> Leslie A. Clark
> IBM Global Services - Systems Mgmt & Networking
> Hello Everybody,
> I have NetView server 5.1.2 running on Solaris 2.6 O/S. Here is
> I am trying to do using Agent Policy Manager.
> Using threshold and Collection policy, obtain bandwidth
> on CISCO 8540 switch/router. Following is the formula
> ((.22.214.171.124.126.96.36.199.1.10.*) *8 *100)/.188.8.131.52.184.108.40.206.1.5.*
> This is the router with full duplex configuration. I am getting
> strange utilization results ( like 325%, 137% ), which is not true.
> If I use xnmcollect from NetView, results are OK. I have also used
> @delta function eventhough by default all counter MIB variables are
> converted into integer and when query these variables it should give you
> delta value.
> Any suggestions?
> Shailesh Patel
> Enterprise Management Services
> Troy MI 48098
> (248) 265-7573