Stephan,
thank you for your answer. I've run into the same kind of problems in
installing it on
AIX 4.3.2. At the moment, StrataView is operational (I haven't really
noticed the status
propagation problem but anyway).
The problem I have is that the SNMPAgent component does not work at all. I
start the
SNMPAgent and it core dumps. It gives the following message:

Setup select/poll problem: Bad file number
SNMPAgent: Error processing configuration.

I've kept the original configuration file for the SNMPAgent (port 8161).
Have you seen anything similar yourself???
Did you have any smux problems at installation???
Any help will be appreciated. I have sent a question to cisco about it.
Thanks

Natasa

-----Original Message-----
From: Stephan Schwalb [mailto:sschwalb AT DEBIS DOT DE]
Sent: Tuesday, October 12, 1999 9:45 AM
To: NV-L AT UCSBVM.ucsb DOT edu
Subject: Re: A?: RE : New Information : Intergration of Transcend NCS
5.1 + NV 5.2 > + AIX 4.3.2 : Can anybod confirm ???


Natasa,

we are running NV 5.1.1 with StrataView+ 9.1.07 (SV+) on AIX 4.2.1 which
should
be similar as
running on 4.3.2. We had some problems at installation (group conflict with
system group "shutdown")
and other stuff but finally we got it. As there are still some problems with
status propagation of
SV-objects we are awaiting SV 9.1.09 where this should be solved (the
maintenance release is already
shipped - may be today or tomorrow we'll have it).

Hope this helps__rgds__Stephan


Vassila Natassa schrieb:

> Unofficially, I have been told that NetView 6.0 will be
> ready at about the end of this year, or in early y2k.
>
> And a question:
> Has anyone attempted to install StataView+ v9.1.07 over
> AIX4.3.2 and NV5.1.1???????
>
> Cheers,
> Natasa
>