Arthur,
If you are talking about cisco's traps.script;
If you look closely at the script merge_trap is just a call for addtrap.  Their
syntax is off for versions 5.x so you have to run a few test to correct it.  I
think the script is actually missing a flag/switch, its been awhile.  Our system
(dev. system) ran fine after running the corrected script, but we did not
implement it in production.

--
========================================================
Drew Wall
Enterprise Management
TEKsystems
mailto:drwall AT teksystems DOT com
http://www.teksystems.com
========================================================


"Boulieris, Arthur" wrote:

> Hello ,
> I am using netview 5.1.
> I have a cisco script to add all cisco traps to netview version 3 and 4
> which I downloaded from the cisco site.I have made it executable but gives a
> syntax error when I run it.
> The script uses a merge_trap instead of addtrap command.
> Does any one know if the merge trap is an old netview command and if so can
> I replace the merge_trap with addtrap in the txt file and run it again,or
> will this destroy my trapd.conf?
> Appreciate any help out there.
>
> thank you Arthur