How about excluding that NAT range in the seedfile.  I'm not sure of the
syntax for excluding ranges...

-----Original Message-----
From:   Discussion of IBM NetView and POLYCENTER Manager on NetView
[mailto:NV-L AT UCSBVM.UCSB DOT EDU] On Behalf Of Prokott, Joe
Sent:   Thursday, May 13, 1999 5:12 PM
To:     NV-L AT UCSBVM.UCSB DOT EDU
Subject:        NV with NAT discovery

Is there a way to configure NetView so that it does not discover NAT
addresses on a device?


Joe Prokott - West Group
Network Architect
610 Opperman Drive
St. Paul, MN  55123
Phone: 651-687-4536
Fax: 651-687-6946
E-mail: joe.prokott AT westgroup DOT com